CATEYE STRADA BATTERY CHANGE TV

I just removed my Strada Wireless (it will go on another bicycle) and put on a Strada Double Wireless - the one with cadence. (And so you know, I'm not afraid of getting wet it just seldom rains in the desert) FYI, I ride in dry weather almost exclusively and haven't had a personal need to check this out. In any case, when the computer reverts back to the current time after several minutes of nonuse, it is effectively in 'idle' and isn't draining the battery by any means.ĭo you ride in wet weather? I've heard (or maybe read on BF) that some cateye users have added some sort of grease (lithium?, electrical?, electrician's?, don't recall which) to the back of the battery to better seal out moisture and protect the contacts. The directions for doing this might be on the instruction sheet. I forget the sequence (hold one, press the other twice?). You actually can put the computer to sleep manually by using the MODE and MENU buttons on the back of the unit. This is the most accurate wheel calibration number.2) From what I can tell, there is no way to turn the unit off? It just goes idle and displays the time, and if I don't use it for 2 weeks it goes into sleep mode? Is that correct? With the riders weight on the bike, roll the wheel one tire revolution in a straight line and mark the ground when the valve stem is perpendicular to the ground again. With the valve stem perpendicular to the ground, mark the pavement at the valve stem. 24h ↔ 12h, or increase the value Switch the screen or move digits (by pressing & holding) Preparing the computer Battery case cover Push! When the computer is mounted on the bracket : Speed unit : Wheel size icon : Sensor signal reception icon Measure wheel circumference (L) of your bike To get the most accurate calibration do a wheel roll out. Set the clock When MODE is pressed and held, “Displayed time”, “Hour”, and “Minute” will appear, in this order. * Refer to the tire circumference reference table. Enter the tire circumference Enter the tire circumference of your bicycle in mm. Select the desired speed units Select “ ” or “ ”. Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by CatEye Co.,Ltd.May void the user ’s authority to operate the equipment.Ĥ km/h ↔ mph Increase Move digits (by pressing & holding) Register the setting Register the setting Clear all data (initialization) Press the AC button on the back. This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1)This device may not cause harmful interference,and (2)this device must accept any interference received,including interference that may cause undesired operation.

Using with other wireless devices in close proximity.

CATEYE STRADA BATTERY CHANGE TV

Close to a railroad crossing, railway tracks, TV stations and/or radar base.Near a TV, PC, radio, motor, or in a car or train.Interference may occur, resulting in incorrect data, if the computer is: Signals can be received only when the back of the computer is facing the sensor.The transmission distance may be shorter due to low temperature or low battery.Signals cannot be received if the distance between the sensor and the computer is too great.When adjusting the wireless sensor, note the following: Wireless Sensor The sensor was designed to receive signals within a maximum range of 70 cm, to reduce chance of interference. LCD screen may be distorted when viewed through polarized sunglass lenses.

Dispose of used batteries according to local regulations.When cleaning the computer, bracket and sensor, do not use thinners, benzene, or alcohol.Over-tightening can damage the bracket threads. Tighten the dial on the Flex-Tight bracket by hand only.Pressing hard on other areas can result in malfunction or damage to the computer. When using the computer installed on the bracket, change the MODE by pressing on the three dots below the screen.

Cateye strada battery change